Save to Eagle

Requirements#

Eagle is a local asset management app. The connection needs:

• Eagle installed and running on this machine;
• Eagle's local API on its default port 41595 (unchanged and not taken).

Viko only sends content to Eagle when you explicitly save — there is no automatic syncing.

Set up the connection (once)#

1. Start Eagle;
2. Open the extension settings and turn on Enable Eagle;
3. Keep the endpoint at the default localhost:41595 (unless you changed it in Eagle);
4. Adjust the default tags if you like (initially viko,ai-generated); they are attached on every save;
5. Click Test connection and confirm it succeeds.

Save a single image#

• After a generation completes, click Save to Eagle in the extension panel or the task detail;
• What is saved: the image, the default tags and the source information.

Save history in bulk#

1. Open the studio History and enter selection mode;
2. Select all or pick tasks one by one;
3. Choose Save to Eagle; success and failure counts are shown when it finishes.

Connection problems#

Three checks in the troubleshooting guide: Eagle is running, the connection is enabled and tested in the extension, and port 41595 has not been changed or taken.